Structuring Water
in the Body & at The Faucet
“Using a state-of-the-art spectroscopic analysis system, Hans Becker determined that something about the ring caused water to emit ultraviolet radiation. Just placing a container of water in the center of a ring would, after only a short period of time, cause the water to emit light in the form of ultraviolet radiation.
Ultraviolet frequencies are related to good health. The healthy body normally has mechanisms by which bio-photons of ultraviolet are produced. Consuming water that emits ultraviolet has a germicidal effect and inhibits the growth and life cycle of any disease-producing organisms that might be in the body. Inside the body, water enters the cellular and intercellular fluids and the bloodstream, providing a simple mechanism for disruption of disease-producing organisms.
If we keep in mind that the body is approximately 70 percent water, it is easy to take this concept one step further. When a human being or an animal steps into the center of a ring and the ring is passed up and down the length of the body, the water in the body is “charged,” the same way a jug of water is “charged,” due to the tensor properties of the ring. It seems reasonable to speculate that this would engender a spontaneous emission of ultraviolet within the bodily tissue and create a bacteriostatic or virustatic state without its even touching the body.
What we have, then, is a noninvasive method for reducing bacterial or viral infections. The early experiments with the ring supported this conclusion when the positive field of the ring enhanced suppression of bacterial and fungal organisms in petri dishes. Slim and Bill were on the right track from the beginning, but the advance of the ring technology through the use of the two wires produced a device with nothing but positive effects. The absence of negative energy combined with the effects of the 144 megahertz frequency seem to be the key components for beneficial treatment of water with the rings, whether in vivo or in vitro.
These key components also give us a clue to the effectiveness of the ring in treating various conditions.”
-Slims Spurling’s UNIVERSE pages 64, 65
How to Structure Your Water
Place a container of water (I have four gallons of water in rings that I rotate as needed, usually at least two-three gallons per day) inside the Tensor Ring overnight or longer to structure the water. The column of energy from the Tensor Ring will restructure the water and make it more of a crystalline structure.
Placing a container or water inside a Tensor Ring creates a high spin rate to the water molecules – so high that it creates Ormus, such as white powdered gold. It makes water lighter and because of its high spin rate, it oscillates in and out of this physical reality – just like Ormus (Orbitally Rearranged Monatomic Elements). That high spin rate is what is restructuring the water making it more of a crystalline structure (where the atoms, molecules, or ions are arranged in a highly ordered microscopic structure, forming a crystalline lattice that extends in all directions), as shown with Dr. Emoto’s work.
Nassim Haramein, a world leader in unified physics, says (and I’ll paraphrase) “Between the scale of the molecules and the cells there is one important step and that is the molecule of water because that is the fundamental crystal transducer that allows the information to go through. This is why all of life emerged from water. Water is not just a neutral medium that DNA just happened to hang out in. If you take the water out, then DNA stops working – and it needs Structured Water. If water loses its structure then the transfer of information via the capacity of the system breaks down. Water will form a special geometry at interfacial surfaces.
A Word on Reverse Osmosis
If you are using a Reverse Osmosis (RO) filtering device you are removing all mineral content and drinking empty water, or distilled water. RO removes all that so to remineralize your structured water here’s what you can do.
Take a glass container – I use a one-cup glass measuring container – and fill to about ¾ full, then add salt – I use Pink Himalayan Salt – to the water. Use a sufficient amount so that after it is stirred well and sits overnight there will be a small amount of undissolved salt. Then add one teaspoon of the water/salt solution to one gallon of water to be structured and sit it inside a 1 Cubit, 333mhz Tensor Ring. Let sit covered overnight for the best results.
An excerpt from “Dancing with Water” by MJ Pangman and Melanie Evens:
“Although Tensor Rings made of all cubit lengths bring molecular structure to water, certain lengths are especially suited for water. In 2015 the authors identified a measurement of 19.65 in. with a resonance, they refer to as the ‘Earth Core’ resonance. Tensor Rings made using this measurement are tuned to the Earth’s central core and to the Earth’s natural energy field. They reconnect water (and anything placed in their energetic field) to the core energy of the Earth. This cubit length is extremely grounding and protective for water.
Tensor Rings are powerful tools. As water passes through (or sits within the energetic column of) a Tensor Ring, it becomes organized. The longer it sits inside the ring the more refined the structure becomes. The pH of the water is often balanced (this depends on the water source) and the taste of the water generally improves. Other improvements that are more difficult to quantify augment the water’s energy. The authors use Tensor Rings during all stages of water preparation. They are especially useful for protecting water during maturation and storage. The column of energy produced shields water from outside interference.”
We Recommend Using the Large Sacred Cubit Ring for the Body: Click Here to View in the Shop
Using the Large Rings:
You can stand in front, behind, or beside your client. Ask for permission. No intention is necessary, but it’s always good to be centered and intend for the highest good of your client. Hold the large ring over their head and slowly lower it. You or they will sense a heavy or sticking sensation, or one of you will simply intuit where there is an area that requires adjustment. Simply raise and lower the ring slowly a few inches above and below the area in question until the heavy sensation is gone. There could be any number of sensations, so don’t be concerned with only one or two ways to detect the area. Complete moving down until the ring is on the ground. That’s all there is to it.
